To display this page you need a browser with JavaScript support.Sludge Thickener, Bridge Supported Centrally Driven - Paramount Limited




EPC, Water Waste Water Treatment, Paramount
    >> Pollution Control Equipments >> Sludge Thickener >> Centrally Driven
 
   

Sludge Thickener
Bridge Supported Centrally Driven

"PARAMOUNT" make picket fence type sludge thickener mechanisms are suitable for installation either in RCC/MS tank. The drive can be used continuously to remove the settled solids from the centre of the tank. The recommended slope is 1:12 at the bottom of the sludge thickener tank for efficient removal of sludge. The sludge is scrapped from the bottom of the tank by rotating scrapper arm.

PARAMOUNT make picket fence type sludge thickener mechanism consist of :-

1.


Proprietary drive unit comprising of worm & worm wheel gear unit connected to standard gear box by means of sprocket and chain arrangement. The gear box in turn is connected directly to motor mounted on a MS fabricated base frame.
   
2.



Superstructure comprising of steel structural bridge spanning the entire diameter of the tank. The drive unit is fixed at the centre of the bridge and the bridge is designed to take the static and dynamic load of the drive unit. Necessary chequered plate and hand rails are provided on the bridge so that it can be used as walkway to have access to the drive unit at the centre.
   
3.
Tubular centre shaft is connected to the adaptor shaft of the drive unit.
   
4.


Two structural steel rake arms are connected to the centre shaft. The rake arms are provided with blades and adjustable brass/neoprene squeezes to rake the tank bottom twice per revolution. The rake arms are also provided with specially designed vertical pickets for efficient compaction of sludge.
   
5.

The bottom of the shaft rests on guide bearing fixed to tank cone. Suitable cone scrapers are included in our supply.
   
6.

Feed well of suitable diameter is fixed to the bridge is also provided to introduce the feed into the clarifier.
   
7.

Necessary weir plates along with fixing bolts to be fixed to the outlet launder can also be provided on request.
   
8.
Anchor bolts for fixing the bridge on to the periphery of tank.
   
9.

Painting - parts are suitably cleaned and steel under water parts are cleaned with wire brush and provided with one coat of red oxide primer. Epoxy painting is provided on special request if required.
   
10.
Access ladders/staircase to the bridge can also be provided on revert.
   
11.
Floating scum scrapper with scum box & high torque switch can also be provided on special request.

Exclusions :-

All civil works, electrical works, erection & commissioning of the mechanism & any other item not specifically mentioned in our proposal.

Sludge Thickener, Centrally Driven

 
 
   
 
   
 
   
 
   
Consultancy Services, Waste Water Treatment, Water Treatment, Sewage Treatment,  Deminerialised Water Treatment,
Air Pollution Control, Flue Gas Desulphurisation, Hazardous Waste Incinerators, Pollution Control Equipments,  
Contact Us,
 Site Map
 
   
 
   
Copyright © Paramount Limited., All rights reserved Paramont Limited, Vadodara, India